Before & After Photos

This homeowner in Southbridge, MA called us hoping that he could get the insulation in his attic replaced. Unfortunately, it had mold, and needed to be replaced as soon as possible. We first removed the attic insulation, leaving the attic bare (as seen in this photo). After remediating the mold (another solution!), we were able to get started on re-insulating this attic.

We first went in with our ZypFoam™ one-part spray foam. This was used to seal all cracks and gaps in the attic floor - any place where the air from the home would leak into the attic and get lost. After air sealing, we then took to insulating the main part of the attic with our TruSoft™ cellulose insulation. TruSoft™ is blown-in insulation -- meaning that it is literally blown into the attic using a large hose. We installed this insulation to the optimum R-value of R-60. Since it is blown in insulation, it avoids thermal bridging by covering framing members and fills all cracks, gaps, and odd shaped voids. Now, this homeowner's house is more comfortable than ever! 

These homeowners in Woodstock, CT had issues with their home being cold. One of the main issues was cold air coming up through their open crawlspace. There was batt insulation in the crawlspace ceiling, but as often happens with batts, it was beginning to sag, leaving space for cold air to get up into the floors and up through the home. This issue would only get worse over time if left unchecked and the cycle will only continue if batt insulation is reinstalled.

We began by pulling out the batted insulation. We then installed our SilverGlo insulation foam across the bottom of the floor joists, or some may call the crawlspace ceiling. The foam is rigid and will not sag or pull away from the joists, there is also a radiant barrier facing on the SilverGlo which will stop conductive heat loss by keeping the warm air inside the home in. The SilverGlo is fastened into place with special long screws and any spaces between them are sealed with expanding foam.

Thanks Dr. Energy Saver by Eco Energy, this home is far more comfortable.

Our Woodstock, CT customer reached out to Fogarty's Home Services because his home was cold and his pipes kept freezing. One issue we found during our customer's free Home Energy Evaluation, was that the exterior walls weren't insulated properly. Nearly all walls leak air, causing drafts. The cold wall surface cools interior air which then sinks and travels across the floor and up the warmer interior wall, and across the ceiling back to the exterior wall. This is called a "convective loop" and makes rooms feel even draftier. To remedy this issue, Fogarty's Home Services dense-packed TruSoft™ cellulose into the exterior walls to stop air flow through the wall and insulate them. TruSoft™ Cellulose is treated to be highly fire, most and pest resistant. When finished, we plugged the insulation holes and put the siding back. Now, our customer has a less drafty, warmer, quieter, more comfortable house with lower fuel/electric bills. At Fogarty's Home Services, We Fix Uncomfortable Homes!

This homeowner in Woodstock, CT called us in the hopes that we would be able to help him with the ice damming that they were experiencing. When our Home Comfort Specialist came out to the home, he noted that the home was old (built in the 1800s) and was not properly insulated. However, this homeowner's attic was particularly hard to insulate for other contractors due to the large amount of ducts and electrical equipment that took up the majority of the attic. 

We were able to help this customer with their attic. We utilized our SuperAttic™ system in order to insulate it appropriately while ensuring enough access to the ducts and equipment in the attic. The SuperAttic™ system is made of our SilverGlo™ foam insulation board. This insulation board is infused with graphite, giving it a superior R-value, and has a foil face on both sides. The roof is still vented, preventing ice damming, but the attic is now part of the conditioned space in this home. A perfect solution for this homeowner's problem! 

This homeowner in Barre, MA called us hoping that we would be able to replace his old and inefficient insulation. When our Home Comfort Specialist arrived, he found that the attic was not air sealed and was insulated with inefficient fiberglass insulation. This meant that there were severe air leaks and temperature issues.

We first had to remove all of the fiberglass insulation. This was bagged and placed in our truck in order to be disposed of. We then vacuumed up the remaining loose insulation. 

After that, we air sealed every gap in the attic. To do that, we utilize Zypfoam™ expanding foam. After doing other necessary services prior to insulation, we install baffles (air chutes) into the rafter bays as necessary. We finally use our TruSoft™ blown-in cellulose insulation, blown in to the optimal R-value. This insulation fills all gaps and voids, and prevents thermal bridging by filling over framing members. This homeowner now has a properly insulated home -- it is warmer, more comfortable, and even quieter!